User Manual
Table Of Contents
- DC68-04006Y-04_IB_WF8500A_EN_240123
- DC68-04006Y-04_IB_WF8500A_CFR_240123
- Consignes de sécurité
- Remarques importantes sur les consignes de sécurité
- Symboles de sécurité importants
- Consignes de sécurité importantes
- AVERTISSEMENT CONCERNANT LA PROPOSITION 65 DE L'ÉTAT DE CALIFORNIE
- Avertissements importants concernant l'installation
- Mises en garde pour l'installation
- Avertissements importants concernant l'utilisation
- Mises en garde concernant l'utilisation
- Avertissements importants concernant le nettoyage
- Notification de réglementation
- Installation
- Avant de démarrer
- Opérations
- Maintenance
- Dépannage
- Caractéristiques techniques
- Consignes de sécurité
- DC68-04006Y-04_IB_WF8500A_MES_240123
- Información sobre seguridad
- Lo que necesita saber sobre las instrucciones de seguridad
- Símbolos de seguridad importantes
- Precauciones de seguridad importantes
- PROPOSICIÓN 65 DE CALIFORNIA: ADVERTENCIA
- Advertencias fundamentales para la instalación
- Precauciones para la instalación
- Advertencias fundamentales para el uso
- Precauciones de uso
- Advertencias fundamentales para la limpieza
- Aviso regulatorio
- Instalación
- Antes de comenzar
- Funcionamiento
- Mantenimiento
- Solución de problemas
- Especificaciones
- Información sobre seguridad
Installation
English24
STEP 3 Adjust the leveling feet
1. Gently slide the washer into position. Excessive force
may damage the leveling feet.
2. Using a wrench, turn the leveling feet clockwise
or counterclockwise to adjust the height until the
washer is level.
3. Using a flathead screwdriver, tighten the locking
nuts (A).
NOTE
Use the open-end of the supplied wrench to adjust the
leveling feet.
STEP 4 Connect the water hose
B
A
CAUTION
• Make sure to use new water hoses and that rubber
gaskets (B) are inside the couplings (A) at both ends
of the hoses. Water hoses without the gaskets may
leak.
• Allow 5 in. (127 mm) of space between the back of
the washer and the wall to prevent water hoses from
being kinked. Kinked hoses may cause water leaks.
• If there is a water leak, stop using the washer and
contact a local Samsung service center. A water leak
may cause electric shock.
• Do not stretch the water hoses by force. If a hose is
too short, replace the hose with a longer hose.
Untitled-1 24 2024-01-18 3:06:04