User Manual
Table Of Contents
- DC68-04006Y-04_IB_WF8500A_EN_240123
- DC68-04006Y-04_IB_WF8500A_CFR_240123
- Consignes de sécurité
- Remarques importantes sur les consignes de sécurité
- Symboles de sécurité importants
- Consignes de sécurité importantes
- AVERTISSEMENT CONCERNANT LA PROPOSITION 65 DE L'ÉTAT DE CALIFORNIE
- Avertissements importants concernant l'installation
- Mises en garde pour l'installation
- Avertissements importants concernant l'utilisation
- Mises en garde concernant l'utilisation
- Avertissements importants concernant le nettoyage
- Notification de réglementation
- Installation
- Avant de démarrer
- Opérations
- Maintenance
- Dépannage
- Caractéristiques techniques
- Consignes de sécurité
- DC68-04006Y-04_IB_WF8500A_MES_240123
- Información sobre seguridad
- Lo que necesita saber sobre las instrucciones de seguridad
- Símbolos de seguridad importantes
- Precauciones de seguridad importantes
- PROPOSICIÓN 65 DE CALIFORNIA: ADVERTENCIA
- Advertencias fundamentales para la instalación
- Precauciones para la instalación
- Advertencias fundamentales para el uso
- Precauciones de uso
- Advertencias fundamentales para la limpieza
- Aviso regulatorio
- Instalación
- Antes de comenzar
- Funcionamiento
- Mantenimiento
- Solución de problemas
- Especificaciones
- Información sobre seguridad
Troubleshooting
English56
Code Action
UB
Check the spinning process.
• The load may not be balanced inside the drum. Check the drum and make sure
the load is balanced.
• Press Start/Pause (Hold to Start) to resume operation or power the washer off,
wait 2-3 minutes, power the washer on, and then try again.
• Make sure the unit is level.
• Make sure the washer is on a flat, stable surface.
8C, 8C1, 8C2
Check the MEMS sensor.
• Power the washer off. Wait 2-3 minutes, power the washer on, and then try
again.
OC
Water may overflow.
• Close the water valve and call for service.
3C
Check the motor.
• Power the washer off. Wait 2-3 minutes, power the washer on, and then try
again.
AC6
Check the PBA communication status.
• Power the washer off. Wait 2-3 minutes, power the washer on, and then try
again.
9C1, 9C2
The electronic control needs to be checked.
• Check if power is supplied properly.
• If the information code remains, contact a Samsung service center.
SF
System failed.
• Power off the washer, and then contact a Samsung service center.
If any information code keeps appearing on the screen, contact a local Samsung service center.
Untitled-1 56 2024-01-18 3:06:12