User Manual

10_ installation

installation

4. Connect the cable to the HDD by matching the HDD

SATA/power cable number to the HDD position number

on the bracket.

` For the HDD location number on the bracket, please refer to the

figure below

5. Mount the bracket on which an additional HDD is

mounted on the NVR, secure it with screws and connect

the SATA/power cable to the connector on the main

board by matching the number.

` For the connector numbers, please refer to the figure below.

6. After ensuring that ther

e is no problem with the

connection terminal and routing inside the product, close

and secure the cover using the screws.

How to install an HDD in WRN-810S

1. First, loosen the screws on the left/right sides and the

rear side, and remove the cover.

2. After connecting one end of the HDD power and data

cable to the HDD, connect the other end to the

connector on the main board.

` See the images for the HDD location number and connect number

of the bracket.

` Gently press the connector before removing the HDD.

Do not force to pull the cable.

3. Using the provided screws, mount the HDD to the

bottom cover.

` Up to two HDDs can be installed. The number of installable

HDDs varies for each model.

4. After ensuring that there is no problem with the

connection terminal and routing inside the product, close

and secure the cover using the screws.