User manual

INSTALLATION
ENVIRONMENT HOW TO CLEAN THE FILTER (In case drain pump)
1. Place a rag under the washer filter
Leave some space not to wet the floor.
Space at last 15cm between the washer 2. Rotate the filter counterclockwise
and the wall. and pull out the filter.
3. Remove dirts and rotate
Place the washer on a sturdy flat surface. the filter clockwise until it
If the washer is placed on an uneven or weak
locks in position.
surface, noise or vibration may be occured.
Remark : Should be cleaned
(Allowable is 2°)
Filter at least 1 time a week.
Never install the washer near water.
CONNECTING THE DRAIN HOSE
Do not place the washer in steamy rooms or Insert the drain hose(a) and push it tighly to be
where the washer is directly exposed to rain.
connected as arrow direction.
Moisture may destroy the electrical insulation
and cause an electrical shock hazard.
Avoid direct sunlight or heating devices. (WITHOUT PUMP)
As plastic and electrical components are
affected by direct heat, never place the
washer near heaters, boilers,etc.
Do not place under direct sunlight.
Install the drain hose(A) about 70~80cm above the
ground
for pump model.
.
CLEANING THE MACHINE
CLEANING THE LINT FILTER OVERFLOW FILTER
If the dregs are filled up in the lint filter after Pull the upper side of the overflow filter
finishing the wash, push down(1) and pull it with two fingers into the hole ‘A
out(2) as shown in figure. in the direction of arrow as
Remove the collected lint and rinse the filter net. shown in the figure.
CLEANING THE COVER WINDOW SPIN
1. Rotate the cover window spin clockwise and pull out.
2. Cleaning the cover window spin.
3. Insert
the cover window spin back and rotate it
counterclockwise until locks in positon.
Remark : Should be cleaned the cover window spin
at least 1 time a month.
CLEANING THE WASH TUB
Wipe off strains on the cabinet and operation
panel with soft cloth. Do not use benzene, thinners,
cleanser, or wax, nor scrub the washer with a brush.
Painted surfaces or plastic parts will be damaged.
3
DC68-01941C_IB_ENG_T12J.indd 4 4/27/2006 9:09:28 AM