User manual

WASHING PROCEDURE
TO WASH
...................................................................................................................................
1. Before starting washing, check the following; 6. Fill water in the
• Connect the water supply hose and open the water tap. wash tub and add
• Connect the power cord to the power supply outlet. the detergent.
• Lay the drain hose(A) down toward a sinkhole.
7. Set the WASH TIMER 1-35 minutes.
(WITHOUT PUMP) SOAK
• Set the WASH TIMER
to the point more
than “15” for SOAK
• Place the drain hose(A) in sink or bath function.
about 70~80cm above the ground. • If the WASH TIMER is
set to the point less
than “15”, it leads to
WASH only. (No SOAK)
(WITH PUMP) • If Although the machine may stay still
maximum 5 minutes, if the WASH
TIMER is indicated over 15 minutes
position, it is just in the process
2. Set the WASH SELECTOR KNOB of soaking and not a breakdown.
to the desired mode.
‘NORMAL or HEAVY’ 8. After washing,set the
CYCLE SELECTOR KNOB
to ‘DRAIN’ for drain.
9. Soak-Washing
1) Place clothes into the WASH TUB.
3. Set the CYCLE SELECTOR KNOB to 2) Turn on tap or use bucket to fill the
‘WASH
.
RINSE’. (In case no drain pump.) WASH TUB with desired amount of
(‘WASH’ In case drain pump.) water.
3) Put detergent depending on the
water volume and detergent
package indications.
4) Set WASH TIMER to point between
“15” to “35” in the timer.
(Without pump) (With pump) • Soak-Washing automatically
starts the wash (15 min.) after the
4. Set the WATER SELECTOR soak (2 to 20 min.) is completed.
KNOB to WASH .
• The SOAK function (20 min.)
repeats the cycle that is
1.5 ~ 2.0 min. turning and
the next 5 min. resting 3 times.
5. Load laundry in the
wash tub.
4
DC68-01941C_IB_ENG_T12J.indd 5 4/27/2006 9:09:32 AM