User Manual
Table Of Contents
- overview
- outdoor vandal dome camera
- indoor dome camera
- flush mount dome camera
- outdoor bullet camera
- box camera
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Using Device Manager
- Automatically searching camera
- Configuring IP address
- Manually registering camera
- Automatically configuring IP
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
36_ outdoor bullet camera
outdoor bullet camera
Installing the camera module
1. Hang the safety cable up on a hook that looks like an arrow in the Bottom cover.
e.g.
2. Connect the network/power/audio/alarm cables to the camera module terminal.
3. Attach the camera body to the Bottom cover.
J
`
Make sure to firmly tighten the fastening screws so that there is no water damage issue.
x4
3x
HEX
S3
4. Adjust the camera direction using the Hex. L wrench provided.
J
`
When you adjust the camera position using a bracket, please loosen the bracket screw, adjust the camera, and tighten it. If
you attempt to adjust it forcibly while the screw is tight, it may result in a scratch or other problems.