User Manual
Table Of Contents
- overview
- outdoor vandal dome camera
- indoor dome camera
- flush mount dome camera
- outdoor bullet camera
- box camera
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Using Device Manager
- Automatically searching camera
- Configuring IP address
- Manually registering camera
- Automatically configuring IP
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
English _41
●● INSTALLATION & CONNECTION
installation & connection
ADJUSTING THE MONITORING DIRECTION FOR THE CAMERA
Pan
Lens rotation
Tilt
`
Adjusting the monitoring direction
You can adjust the camera direction only when the camera is fixed on the ceiling.
At this time, rotating the main body of the camera in the left and right direction is called PAN, and adjusting
the angle of the camera is called TILT.
- The pan angle is 0˚ – 360˚.
- The tilt angle is -45˚ – 85˚.
- The rotation angle is 0˚ – 355˚.
J
`
In 75˚ or more tilt angle, a blockage of view or burred image may occur in some part of the screen depending on the
zoom magnification.
`
Do not forcefully rotate or press the focus/zoom lens. Otherwise, the focus might not work properly due to motor failure.
`
Methods of adjustment
1. Adjust the pan angle taking account of the direction to monitor.
2. Adjust the horizontal angle so that the video does not flip when rotated.
3. Adjust the tilt angle toward the direction to monitor.
J
`
Adjust the direction of IR LEDs not to hinder their view by an instrument.
J
`
Adjust the direction of IR LEDs not to hinder their view by a weather cap (if any).