User Manual

English _13
●● INSTALLATION & CONNECTION
INSTALLATION (XNV-6010/6020R/8020R/8030R/8040R)
J
`
This camera is waterproof and in compliance with the IP66/IP67 spec, but the jack connected to the external cable is not. You
are recommended to install this product below the edge of eaves to prevent the cable from being externally exposed.
Precautions before installation
Ensure you read out the following instructions before installing the camera:
• It must be installed on the area (ceiling or wall) that can withstand 5 times the weight of the camera
including the installation bracket.
• Stuck-in or peeled-off cables can cause damage to the product or a fire.
• For safety purposes, keep anyone else away from the installation site.
And put aside personal belongings from the site, just in case.
• If you use excessive force when installing the product, the camera may be damaged and malfunction.
If you forcibly install the product using non-compliant tools, the product may be damaged.
Disassembling
1. Using the L wrench provided, turn the 2 fastening bolts
on the dome cover counter clockwise to remove the
cover.
1
2
FRONT
USB
VIDEO
DC 12V
RESET
1 2 3 4 5 6 7
AC 24V / DC 12V
RESET
VIDE O
F
W
AF
T
N
+ -
Bolts
Dome cover
Camera Case
Camera Body
Installation
1. Drill a hole (diameter : 6mm, depth : min 55mm) of the case
bottom and insert the provided plastic anchor to the end.
2. Fit the bottom hole to the anchor hole and insert and fix the taping
screw.
3. Connect and arrange the necessary cables lest that they should
be damaged or twisted while installing the camera.
4. Adjust the lens in a desired direction by referring to the “Adjusting
the monitoring direction for the camera” section. (page 15)
5. Close the dome cover.
`
Securely fasten the fastening bolt using an L wrench to prevent water from
leaking.
Connecting waterproof power cable and LAN cable
1. Remove the dome cover and the case.
2. Pull out the long projected part of the rubber plug on the bottom and
remove it as shown in the figure.
J
`
Use an appropriate cable bush for the LAN cable to be connected.
-
Basic camera : Use the cable with a diameter of Ø5~6.5.
-
Components provided : Use the cable with a diameter of Ø7~8.5.
3. Insert the power cable into the small hole made by removing the projected
part of the rubber plug in step 2 above, and lay the cable along the long
groove.
4. Connect the power cable with the power terminal block.
1
2
FRONT
USB
VIDEO
DC 12V
RESET
1 2 3 4 5 6 7
AC 24V / DC 12V
RESET
VIDEO
F
W
AF
T
N
+ -
1
2
ACT LINK
NETWORK
CAUTIO N: Be ware o f the
Rated Voltage and P olari ty
of the power conne ction .
1
2
FRONT
USB
VIDEO
DC 12V
RESET
1 2 3 4 5 6 7