User Manual
Table Of Contents
- overview
- outdoor vandal dome
- indoor vandal dome
- flush mount dome
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Buttons used in IP Installer
- Static IP Setup
- Dynamic IP Setup
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
10_ outdoor vandal dome
outdoor vandal dome
Removing a Micro SD Memory Card
Gently press down on the exposed end of the memory card as shown in the diagram to eject the memory
card from the slot.
J
`
Please note that if you firmly push and release the Micro SD memory card when it is ejected, it may pop out.
`
Before removing the Micro SD memory card, in <Storage>, set the device to <Off> and press the [Apply] button and turn
the camera off.
`
If you turn off the camera or remove the Micro SD memory card that contains data from the product, the data may be lost or
damaged.
Installing the AC module (sold separately: SPC-100AC)
1. Install the AC module as shown in the figure.
2. Tighten the screw using the hex key.
x4
1x
TR20