User Manual
Table Of Contents
- overview
- outdoor vandal dome
- indoor vandal dome
- flush mount dome
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Buttons used in IP Installer
- Static IP Setup
- Dynamic IP Setup
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
14_ outdoor vandal dome
outdoor vandal dome
Installing the camera module
1. Connect the LAN/power/audio & alarm cables to the camera module terminal.
2. Attach the camera module to the case.
J
`
A magnet is embedded at the bottom of the module
`
Take caution not to allow any foreign objects between the attaching surfaces.
* AC
3. Adjust the lens to the desired direction with reference to “Adjusting the monitoring direction for the
camera” section. (page 33)
Assembling the dome cover
[Directly installing on wall/ceiling]
1. Assemble the dome cover.
J
`
Make sure to firmly tighten the fastening screws so that there is no water damage issue.
`
Be careful when using the AC module as the dome cover has a certain working direction.
x4
4x
TR20
J
`
Be careful not to alter the monitoring direction of your camera.