User Manual
Table Of Contents
- overview
- outdoor vandal dome
- indoor vandal dome
- flush mount dome
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Buttons used in IP Installer
- Static IP Setup
- Dynamic IP Setup
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
English _19
●● INDOOR VANDAL DOME
Removing a Micro SD Memory Card
Gently press down on the exposed end of the memory card as shown in the diagram to eject the memory
card from the slot.
J
`
Please note that if you firmly push and release the Micro SD memory card when it is ejected, it may pop out.
`
Before removing the Micro SD memory card, in <Storage>, set the device to <Off> and press the [Apply] button and turn
the camera off.
`
If you turn off the camera or remove the Micro SD memory card that contains data from the product, the data may be lost or
damaged.
Installation (mount plate)
[Directly installing on wall/ceiling]
1-1. Attach the installation template on the desired surface and drill holes for screws and cables.
1-2. Fix the mount plate using appropriate screws.
1-3. Pull out necessary cables among LAN/power/audio & alarm cables through the hole in the mount plate.