User Manual
Table Of Contents
- overview
- outdoor vandal dome
- indoor vandal dome
- flush mount dome
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Buttons used in IP Installer
- Static IP Setup
- Dynamic IP Setup
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
22_ indoor vandal dome
indoor vandal dome
Installing the camera module
1. Connect the LAN/power/audio & alarm cables to the camera module terminal.
2. Attach the camera module to the case.
J
`
A magnet is embedded at the bottom of the module
`
Take caution not to allow any foreign objects between the attaching surfaces.
3. Connect the microphone cable to the camera module.
4. Adjust the lens to the desired direction with reference to “Adjusting the monitoring direction for the
camera” section. (page 33)
[Installing audio & alarm cables]
3-1. Mount the bush of the provided audio & alarm cables to the camera case.
4. Join the mount plate with the camera case.
x4
2x
TR20