User Manual
Table Of Contents
- overview
- outdoor vandal dome
- indoor vandal dome
- flush mount dome
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Buttons used in IP Installer
- Static IP Setup
- Dynamic IP Setup
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
English _23
●● INDOOR VANDAL DOME
Assembling the dome cover
[Directly installing on wall/ceiling]
1. Assemble the dome cover.
J
`
Make sure to firmly tighten the fastening screws so that there is no water damage issue.
x4
4x
TR20
J
`
Be careful not to alter the monitoring direction of your camera.
Using/Removing Skin cover
1. Put on the skin cover in alignment with the pipe cover.
2. For a camera connected with a pipe, remove the pipe cover from the skin cover first before putting it on.