User Manual

26_ flush mount dome
flush mount dome
INSTALLATION
J
`
This camera is waterproof and in compliance with the IP52 spec, but the jack connected to the external cable is not. You are
recommended to install this product below the edge of eaves to prevent the cable from being externally exposed.
Precautions before installation
Ensure you read out the following instructions before installing the camera:
• Select an installation site that can hold at least 5 times the camera’s weight.
• Stuck-in or peeled-off cables can cause damage to the product or a fire.
• For safety purposes, keep anyone else away from the installation site.
And put aside personal belongings from the site, just in case.
• If the product is installed with excessive force, it may cause damage to the camera due to malfunction.
Forcing assembly using non-compliant tools may damage the product.
Removal
1. Peel off the tape fixing the camera case.
2. Take off the cushion protecting the camera lens.
Inserting a Micro SD Memory Card
Slide the Micro SD card into the Micro SD slot on the camera module in the direction of the arrow.
J
`
Before installing the camera, the Micro SD memory card should be inserted while the power source and the body are
separated.
`
Do not forcefully insert it in the reverse direction. It might damage your Micro SD memory card and your product.
`
When it rains or the humidity is high, insertion or ejection of a Micro SD card is not recommended.
`
When installing/removing the Micro SD memory card, make sure you put the product body on a flat ground before working on it
in order to prevent accidents due to loss or drop of any parts.