User Manual

10_ installation & connection
installation & connection
INSTALLATION
J
`
This camera(XNF-8010RV/XNF-8010RVM) is waterproof and in compliance with the IP66 spec, but the jack connected to the
external cable is not. You are recommended to install this product below the edge of eaves to prevent the cable from being
externally exposed.
Precautions before installation
Ensure you read out the following instructions before installing the camera:
• Select an installation site that can hold at least 5 times the camera’s weight.
• Stuck-in or peeled-off cables can cause damage to the product or a fire.
• For safety purposes, keep anyone else away from the installation site.
And put aside personal belongings from the site, just in case.
Disassembling
Using the L-wrench provided, loosen 3 screws by turning them
counterclockwise and separate the cover top.
`
Note that it is not necessary to loosen the screws completely.
Installing the camera on the ceiling or a wall
1. Select a location where you want to install the camera.
2. Insert the provided screw into the camera hole and turn it
clockwise.
3. Close the cover top and turn it clockwise using the L-wrench.
J
`
To fix the cover, you should match the triangular arrows to assemble
correctly.
`
If the cover is not fixed tightly, you may encounter a problem with
waterproofing. (IP66) (XNF-8010RV/XNF-8010RVM)
How to connect the RJ45 waterproof cable to a LAN cable (XNF-8010RV)
1. Insert it through the arrow direction.
2. Connect the LAN connector (male) to the cable.
3. Connect the RJ45 modular jack (female) to the RJ45 connector
(male).
J
`
Please, keep each of the parts separated.
4. Assemble by rotating the RJ45 modular jack (female) and the RJ45
protection cover clockwise (Follow the arrow).
5. Assemble by rotating RJ45 protection cover and back cover
clockwise (Follow the arrow).
When the back cover is assembled, the cable waterproof gasket is
tightly attached to the cable to make it waterproof.
J
`
You must fully assemble it to rotate the back cover up to the end of the screw
thread of the RJ45 connector.
RJ45 connector
(male)
RJ45 modular
jack (female)
Rubber ring
RJ45 connector
protection cover
Back cover
Cable waterproof
gasket
Rubber ring
Fixing Hole