User Manual

English _11
●● INSTALLATION & CONNECTION
Outdoor installation (XNF-8010RV/XNF-8010RVM)
When you install the camera outdoors, it should be waterproofed with waterproof butyl rubber tape (which
can be purchased in stores) so that water does not leak from the gap of the cable connected in the outdoor
area.
1. Connect the power, audio I/O and LAN cables.
2. Wrap the black cable jacket (Area A) and the cable connection
area with waterproof (butyl rubber) tape so that more than half of
the butyl rubber tape is overlapped.
J
`
If the cable jacket is not waterproofed properly, then it can directly cause
leakage. Make sure to protect the cable with a dense layer of taping.
`
Waterproof butyl tape is made of butyl rubber that can be stretched to
twice its normal length.
INSERTING/REMOVING A MICRO SD MEMORY CARD
J
`
Disconnect the power cable from the camera before inserting the Micro SD memory card.
`
Do not insert the Micro SD memory card while it’s upside down by force.
Otherwise, it may damage the Micro SD memory card.
`
When it rains or the humidity is high, insertion or ejection of a Micro SD card is not recommended.
`
Disassembly of the product cover should be finished within 5 minutes, or there will be the risk of internal dew condensation.
Inserting a Micro SD Memory Card
1. Separate the cover top of the camera.
2. Insert a Micro SD card in the arrow direction shown in the figure.
Camera
Camera
Camera
System
System
System
AA
Removing a Micro SD Memory Card
Gently press down on the exposed end of the memory card as shown in the diagram to eject the memory
card from the slot.
J
`
Pressing too hard on the Micro SD memory card can cause the card to shoot out uncontrollably from the slot when released.
`
Before removing the Micro SD memory card, in <Storage>, set the device to <Off> and press the [Apply] button and turn
the camera off. (Page 43)
`
If you turn off the camera or remove the Micro SD memory card that contains data from the product, the data may be lost or
damaged.