User Manual

installation & connection
14_ installation & connection
Connecting to Audio Input/Output
1. Connect the AUDIO IN port of the camera with the microphone or LINE OUT port of the amplifier that the
microphone is connected to.
M
`
You can use the built-in microphone in the camera without connecting an external microphone.
2. Connect the AUDIO OUT port of the camera with the speaker or LINE IN port of the amplifier that the
speaker is connected to.
3. Check the specifications for audio input.
• Audio Codec
- Audio In : G.711 PCM (Bit Rate: 64kbps / Sampling Frequency: 8kHz), G.726 ADPCM (Bit Rate:
16Kbps, 24Kbps, 32Kbps, 40Kbps / Sampling Frequency: 8kHz), AAC (Bit Rate: 48Kbps / Sampling
Frequency: 16kHz)
• Full duplex Audio
• Audio in : Selectable (microphone/Line-in/Built-in microphone), Supported voltage: 2.5VDC (4mA), Input
impedance: 2K Ohm
• Audio out : Line-out (3.5mm mono jack), Maximum output: 1Vms
• Line out impedance : 600Ω
Connecting a connector cable (XNF-8010RVM)
Connect the M12 male connector into the hole of the M12 Female connector of the camera.
M
`
This camera uses Female, D-coded types.
`
PoE (Power over Ethernet) is supported.
`
You are recommended to use a shielded network connector.
J
`
Connect this camera to a shielded network cable (STP).
`
Please, use 4 poles, Male, D-coded type external cables that meet the M12 specification.
`
Check whether the PoE device is properly connected to the ground.
Powering and networking (XNF-8010RVM)
J
`
A connection method may vary depending on the installation environment of a user.
`
Connect to a PoE (Power over Ethernet) enabled router’s PoE connector.
`
Use PoE (Power over Ethernet) that is compliant with the IEEE802.3af protocols.
You can only use a Mode A PoE device that supplies power through data pin pair 1, 2, 3, 6.
`
Even if you use the M12-RJ45 conversion cable, you can only use a mode A type PoE equipment that supplies power to data
pair pins 1, 2, 3, 6.
Power Cable Specification for Each Model
In case of DC 12V Input:
Wire Type (AWG) #22 #20 #18
Cable Length (Max.) 24m 38m 60m
Network Cable Specification
Item Contents Remark
Connector RJ45 (10/100BASE-T)
Ethernet 10/100BASE-T
Cable UTP Category 5e
Max Distance 100M DC Resistance
≤
0.188 Ω/m
PoE Support IEEE 802.3af
TX+
TX-
RX-
RX+
Speaker
Speaker
Amp
Microphone
MicrophoneAmp