User Manual

setup screen
32_ setup screen
IP & Port
1. From the Setup menu, select the <Basic ( )> tab.
2. Click <IP & Port>.
3. Click <IP address>.
4. Set the <IPv4 setup>.
• IP type : Select an IP connection type.
- Manual : Sets the IP address, subnet mask, gateway,
DNS1, DNS2 and host name.
- DHCP : Specify the DNS1 and DNS2.
- PPPoE : Specify the DNS1, DNS2, ID and Password.
`
If you set it to <Manual>, you should specify the IP, Subnet mask, Gateway, DNS 1 & 2 manually.
• MAC address : Shows the MAC address.
• IP address : Displays the current IP address.
• Subnet mask : Displays the <Subnet mask> for the set IP.
• Gateway : Displays the <Gateway> for the set IP.
• DNS1/DNS2 : Displays the DNS(Domain Name Service) server address.
• Host name: Displays the host name.
5. Set the <IPv6 setup>.
`
Set to <Use> to use IPv6 address.
• Default : Use the default IPv6 address.
• DHCP : Display and use the IPv6 address obtained from the DHCP server.
• Manual : Enter IP address and gateway manually and use it.
J
`
The IP addressing system will be defaulted to DHCP. If no DHCP server is found, the previous settings will be restored
automatically.
`
Once completed with editing, click [Apply] to apply changes and the browser exits. After a while, connect again with the
changed IP.
6. Click <Port>.
7. Type in each item in the Port menu as necessary.
`
Neither the port range between 0 and 1023 nor port 3702 is available.
• HTTP : HTTP port used to access the camera via the web
browser.
The default is 80(TCP).
`
Setting the HTTP port for Safari and Google Chrome browsers to
65535 is not allowed by security policy.
• HTTPS : In this version, the security of the web communication protocol HTTP is strengthened. It can
be used when you set HTTPS mode in SSL.
The initial value is set to 443(TCP).
`
The available setting range is 1024~65535. (For security reasons, in your Safari or Google Chrome browser, you may not use
65535 as your HTTPS port.)
• RTSP : Used to transfer videos in the RTSP mode; the default is 554.
• Timeout : When connecting to RTSP, this function resets the connection if there’s no response for a
certain time.
M
`
If changed the HTTP port, the browser exits.
Afterwards, address should contain the newly assigned HTTP port trailing the IP.
ex) IP address: 192.168.1.100, HTTP port : Assigned 8080

http://192.168.1.100:8080
(If HTTP port is set to 80, no need to specify the port number)
`
Using RTSP and HTTPS is recommended in order to prevent the image information from being restored.
8. When done, click [Apply].