User Manual

English _39
●● SETUP SCREEN
Focus setup
You can set the focus of the video.
1. From the Setup menu, select the <Video & Audio (
)>
tab.
2. Click <Focus setup>.
3. Set the focus according to the following procedures.
If you select <Quick Focus mode>, the focus will be quickly
adjusted.
1) Focus initialize : Click the [Reset] button.
Move the focus to the default location (x1).
`
Precaution : It is recommended to initialize the focus during the initial
use of the camera.
2) Simple focus : Drags the mouse on the screen to designate a position on which to set the auto focus.
Press the [
] button to automatically focus the video.
3) Focus (lens adjustment) : Adjusts the lens focus (Far

Near) and sharpens the image.
J
`
The Simple focus mode may not fit correctly in the following cases:
-
Sudden change to the object in Simple focus mode (sudden movement, appearance or disappearance)
-
Radical change to the brightness in Simple focus mode
-
Image of a low contrast
-
If the camera is exposed to a strong light source in the front or surroundings
-
If you don’t initialize the focus, the focus adjustment may malfunction.
`
In case the focus is inappropriate apart from mentioned above, use [ , , , , , ] button to
manually adjust the focus.
`
In a situation where Simple focus is hardly applied, try to use the manual focus mode.
WiseStream
This is the feature that optimizes the size of the video data by reducing the bit rate through increasing the
compression of the parts where there is no movement after detecting the complexity in the image.
1. From the Setup menu, select the <Video & Audio (
)>
tab.
2. Click <WiseStream>.
3. Select wise stream mode.
- Off : Wise Stream function will be disabled.
- Low ~ High : use the wise stream to select the bit rate
reduction level.
4. When done, click [Apply].
J
`
In the following cases, the WiseStream function may malfunction.
-
Sudden screen switch may cause distortion of the video.
-
It is not appropriate to use in an environment with too much movement and motion on the screen.
NETWORK SETUP
DDNS
DDNS is an abbreviation of Dynamic Domain Name Service that converts the IP address of a camera into a
general Host Name so that the user can easily remember it.
J
`
You can use the DDNS service only if the internet is connected.
1. From the Setup menu, select the <Network (
)> tab.
2. Click <DDNS>.
3. Select the <DDNS> connection type.
4. Type in the DDNS items according to the selected type.
• Wisenet DDNS : Select this if you use the DDNS server
provided by Hanwha Techwin.
- Product ID : Enter the product ID that is registered with
the Wisenet DDNS service.
- Quick connect : It sets port forwarding automatically when used with a UPnP (Universal Plug and
Play) supporting router.
M
`
If you want to use the DDNS service without using a hub that supports the UPnP function, click Quick connect, then
go to the hub menu and activate port forwarding for your hub.
For more on how to set port forwarding for your hub, refer to “Port Range Forward (Port Mapping) Setup”. (page
20)
• Public DDNS : Select one of provided public DDNS servers when you use a public DDNS server.
- Server : Select desired public DDNS service server.
- Host name : Enter the name of the host that is registered with the DDNS server.
- User name : Enter the user name for the DDNS service.
- Password : Enter the password for the DDNS service.
5. When done, click [Apply].
J
`
If selected <Quick connect>, be sure to select Wisenet DDNS service.