User Manual

installation & connection
14_ installation & connection
10. Adjust the lens to the desired direction with reference to “Adjusting the monitoring direction for the
camera” section.
11. Assemble the top cover.
4x
TR20
J
`
When assembling the top cover, make the ‘FRONT’ mark on the camera body align with the logo on the cover.
`
If the cover is not fixed tightly, you may encounter a problem with waterproofing. (IP66 / IP67 / IP6K9K)
`
After installing the product, the screw caps provided as accessories must be used. NSF certification must be complied with
for the specifications of this.
Outdoor installation
When you install the camera outdoors, it should be waterproofed
with waterproof butyl rubber tape (which can be purchased in
stores) so that water does not leak from the gap of the cable
connected in the outdoor area.
1. Connect the power, audio I/O and LAN cables.
2. Wrap the black cable jacket (Area A) and the cable connection
area with waterproof (butyl rubber) tape so that more than half of
the butyl rubber tape is overlapped.
J
`
If the cable jacket is not waterproofed properly, then it can directly cause leakage. Make sure to protect the cable with a
dense layer of taping.
`
Waterproof butyl tape is made of butyl rubber that can be stretched to twice its normal length.
Adjusting the monitoring direction for the camera
`
Adjusting the monitoring direction
You can adjust the camera direction only when the camera is fixed on the ceiling.
Where, Turning the lens on its axis is called Rotation.
- The effective range of rotation is a total of ±180 degrees.
`
Methods of adjustment
To adjust the camera direction, grab the lens holder and turn it while looking at the direction display.
J
`
To adjust the camera monitoring direction, grab the lens holder and turn it.
If you grab the lens to adjust the direction, the focus could be out or fingerprints could remain on the surface.
`
When using the IR Manual mode of the camera, install it with the following installation precautions in mind. (page 15)