User Manual

English _15
! INSTALLATION & CONNECTION
Installation precautions when using the IR Manual mode
~
This mode is recommended when the luminance from each direction is different when monitoring under
low luminance.
~
Since the position of the IR LED is fixed, if you rotate the camera lens, only the monitoring video of the
camera will rotate but not the irradiation direction of the IR LED.
~
Make sure the factory default direction of the FRONT mark is placed right when installing it.
~
Even after the complete installation of the camera, you can customize it using the video rotation if
necessary.
[Example of installing the ceiling mount]
ZONE #1ZONE #1
ZONE #3ZONE #3
ZONE #2ZONE #2
<Factory default direction>
<The direction when using the rotation mode>
ZONE #1ZONE #1
ZONE #3ZONE #3
ZONE #2ZONE #2
CONNECTING WITH OTHER DEVICE
Monitor for installation
Power
WiFi dongle
PoE Router
Ethernet
J
`
The Test Monitor Out port of the product is provided for easier installation, and is not recommended for monitoring purposes.
`
The Micro USB port of the product is provided for easier installation, and is not recommended for monitoring purposes.
Ethernet Connection
Connect the Ethernet cable to the local network or to the Internet.
Powering and networking
Connect the PoE device with the PoE port of the camera.
J
`
Connect and use a PoE enabled router.
`
If you connect using an PoE enabled router, you don’t need a separate power supply cable to power it on.
`
Use a PoE device that complies with the IEEE 802.3at standard.