User Manual

English _9
! OVERVIEW
Inside
Item Description
a
Focus Control Button
Press this button for automatic focus control.
b
MICRO USB port
Port to connect the WiFi dongle.
You can check the installation video through the applications installed in the smartphone.
Refer to “Connecting WiFi” on page 16.
`
Wifi dongle and OTG adapter are sold separately.
c
Reset Button
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that DHCP can be
enabled. If there is no DHCP server in the network, you must run the Device Manager
program to change the basic network settings such as IP address, Subnet mask,
Gateway, etc., before you can connect to the network.
d
Test monitor out port
Output port for test monitoring the video output. Use the test monitor cable to connect to a
mobile display and check the test video.
e
Alarm I/O / Power port
(DC 12V)
Connects the large port part of the audio/alarm/power cable for the connection of Alarm I/O
and power.
f
Audio cable port
Connects the small port part of the audio/alarm/power cable for the connection of speaker
and microphone.
Item Description
g
Network Port Used to connect the PoE or Ethernet cable for network connection.
h
IR LED These infrared LED’s are controlled by the illumination sensor.
i
Fisheye lens This lens has 360˚ vision and it can record video panoramically.
j
Illumination Sensor Detects incoming light to control the IR LED.
k
Micro SD card slot Compartment for the Micro SD card.
b ca
d fe g
h ji
k