User Manual

English _69
Event Setting
You can set the interval and type of the event that will be sent to the user.
Setup > Network > E-mail > Event
• Event Interval : Set the event interval.
` If a series of events occurs, the e-mail will be sent at the specified interval, not on each event.
Recipient Setting
You can create a group and add users to it or; you can delete users and change a group.
Setup > Network > E-mail > Recipient
• Click on < > to add a group.
Enter the group name.
• Select a recipient group to receive emails.
If a group is added, it will appear in the group list.
• Click on <
> to add a recipient.
Select a group and enter names and email addresses.
If a group is created, you can add a recipient.
SNMP
The SNMP protocol allows system or network administrators to remotely monitor and configure the network
devices.
Setup > Network > SNMP
• Enable SNMP v1 : SNMP v1 is used.
• Enable SNMP v2c : SNMP v2c is used.
- Read Community : Enter the name of read-only community to access the SNMP information. By default it is
set to <public>.
- Write Community : Enter the name of write-only community to access the SNMP information. By default, it is
set to <private>.
• Enable SNMP v3 : SNMP v3 is used.
- Password : Set the initial user password for SNMP version 3.
• Enable SNMP Traps : SNMP trap is used to send important events and conditions to the Admin System.
- Trap Manager : Enter the IP address to which messages will be sent.
● SETUP