User guide

COLOR DOME CAMERA SUD-3080
38
COLOR DOME CAMERA SUD-3080
39
Operating Your Camera

PRIVACY : Mask an area you want to hide on the screen.
1)  When the SPECIAL menu screen is displayed, press the Function Setup
switch so that
the arrow indicates ‘PRIVACY’.
 2)  Set up the mode using the Function Setup
switch .
ú AREA : You can select up to 12 PRIVACY areas.
ú MODE : Determines whether to use the area selected in the AREA.
ú MASK COLOR : Determine area color. You can select Green, Red, Blue, Black, White, Gray.
ú TRANSPARENCY : Adds or removes transparency from the masking area.
ú SEL POS/ XPOS/ YPOS : Adjust the size and position of the selected area.
ú RETURN : Select this to save the PRIVACY menu settings and return to the SPECIAL menu.

DIS (Digital Image Stabilizer) : This function mitigates any picture movement due to external
factors such as wind.
PRIVACY AREA SETUP
1.AREA AREA1
2.MODE OFF
3.MASK COLOR GREEN
4.
TRANSPARENCY OFF
5.SEL POS
L_TOP
6.XPOS 10
7.YPOS 10
8.RETURN
Ķ RETURN : Select this to save the MASK AREA menu settings and return to the
INTELLIGENCE menu.
ú SENSITIVITY : Set the sensitivity of the motion detection. When adjusting the
sensitivity, note that the lower the level means the higher sensitivity.
ú DETECT SIZE :
Selects an object size to detect on the screen. When adjusting the detection
size, note that the higher the level means the bigger detection size.
ú RETURN : Select this to save the INTELLIGENCE menu settings and return to the
SPECIAL menu.
• As the DIS function uses the digital zoom, the camera's resolution will decrease.
• DIS doesn’t operate when background illumination is too low.
• DIS doesn’t operate when object pattern is monotonic as like sky or white wall.
Notes

COMM ADJ (Communication Adjustment) :
This function sets up the camera communication status when controlling the camera
through an external control device.
 1)  When the SPECIAL menu screen is displayed, press the Function Setup switch so that
the arrow indicates ‘COMM ADJ’.
 2)  Set up the mode using the Function Setup switch.
ú CAM ID : Determines the camera's identification number (between 0 and 255).
ú BAUD RATE : You can select 2400/4800/9600/19200/38400/57600 bps.
ú UART MODE : You can select NONE, EVEN or ODD for the parity bits.
ú RET PKT : Determines whether to send a command back to the controller device when a
communication control command is sent to the camera.
ú DISP ID : Display camera title on top left corner of the screen.
ú PROTOCOL : Select the communication PROTOCOL. (SAMSUNG-T, SAMSUNG-E , PELCO-D,
PELCO-P, BOSCH, HONEYWELL, VICON and PANASONIC)
ú RETURN : Select this to save the PRIVACY menu settings and return to the SPECIAL menu.
COMM SETUP
1.CAM ID 1
2.BAUD RATE 9600
3.UART MODE 8-N-1
4.RET PKT ENABLE
5.DISP ID OFF
6.PROTOCOL SAMSUNG-T
7.RETURN
* Initial value of communication adjustment
Item
Camera ID BAUD RATE UART MODE PET PKT
Initial value
1 9600 8-NONE-1 ENABLE