User's Manual
Table Of Contents
- Contents
- Figures
- Introduction
- Installation
- Operation
- Troubleshooting
- Specifications
- Reader Specifications
- Environmental Specifications
- Battery Specifications (Optional)
- Power Supply Specifications
- RS-232 Connector Specifications
- RS-485 Connector Specifications
- RS-485/Ethernet Jumper Setting
- Ethernet LAN Connector Specifications
- Digital I/O Connector Specifications
- Optional Communication Cable Specifications
- Suitable Antenna Specifications
- Regulatory Standards
- Reader Configuration
- Tag Programming
- Configuring the IP Address
Installation
11
Figure 8–MP9320 V2.8 Base Plate with Mounting Keyholes
Hollow Concrete Block Wall Mounting
To temporarily mount the MP9320 V2.8 to a hollow concrete block wall, SAMSys
recommends metal sleeve type concrete anchors that accept a #10 screw and flat
washer. To install the reader on a hollow concrete block wall, perform the
following.
1. Refer to Figure 8, and mark the location of the mounting screws. Do not
install the anchors into the mortar joint.
2. Drill the appropriate size hole for a metal sleeve type anchor.
3. Install the anchors.
4. Install the washers and insert the screws.
5. Tighten the screws to within .375” of the anchor.
6. Install the reader and finish tightening the screws.
6.40 in (162.5 mm)
5.0 in
(127 mm)
.359 in Ø
(9 mm)