User's Manual

MP9320 V2.8 User’s Guide
12
Solid Concrete Wall Mounting
To temporarily mount the MP9320 V2.8 to a solid concrete wall, SAMSys
recommends one-piece expansion type concrete anchors that accept a #10 screw
and flat washer. To install the reader on a concrete wall, perform the following.
1. Refer to Figure 8, and mark the location of the mounting screws.
2. Drill the appropriate size hole for a expansion type anchor and install the
anchors.
3. Install the washers and insert the screws.
4. Tighten the screws to within .375” of the anchor.
5. Install the reader and finish tightening the screws.
Wood or Metal Wall Mounting
To temporarily mount the MP9320 V2.8 to a wood or sheet metal wall, SAMSys
recommends either #10 x 1 inch wood screws or #10 x 3/4 inch sheet metal screws
and washers. To install the reader on a wood or metal wall, perform the following.
1. Refer to Figure 8, and mark the location of the mounting screws.
2. Drill the appropriate size hole for screws.
3. Install the washers and insert the screws.
4. Tighten the screws to within .375” of the surface.
5. Install the reader and finish tightening the screws.
Drywall Mounting
To temporarily mount the MP9320 V2.8 to drywall or sheetrock, SAMSys
recommends either #10 toggle bolts or #10 drywall anchors.
NOTE: There are many types of screw-in, hammer-in, and predrill drywall anchors. Each one is
designed for specific applications and pull-out ratings. Ensure that the anchor you select
has a pull-out rating of at least 12 lbs.
To install the reader on drywall or sheetrock, perform the following.
1. Refer to Figure 8, and mark the location of the mounting screws.
2. Refer to the anchor manufactureres instructions for installing the anchors.
3. Install the washers and insert the screws.
4. Tighten the screws to within .375” of the surface.
5. Install the reader and finish tightening the screws.