User's Manual

MP9320 V2.8 User’s Guide
14
Every effort has been made to ensure the MP9320 V2.8 is configured to match
your application. However, it is recommended that the reader configuration be
verified before placing the reader into service. If the system is to be used as a local,
standalone reader connected to a terminal or PC, perform the following:
1. Verify all antennas, cabling and power supplies are secure.
2. Verify the operator terminal or PC is connected to the reader and operational.
3. Power up the reader.
4. Launch RF Command Suite.
5. Set the terminal serial port parameters to default values (57600, 8, 1, none).
6. Introduce a test tag into the RF field.
7. Verify the tag was read correctly.
8. If the tag did not read correctly, use RF Command Suite to verify the reader
operating mode matches the application requirements (refer to Appendix A).
If necessary, reconfigure the reader operating modes.
NOTE: Refer to the RF Command Suite User’s Guide and the Comprehensive Heuristic
Unified Messaging Protocol (CHUMP) Reference Guide for detailed information
on configuring the reader.
Ethernet LAN Communication Setup
The MP9320 V2.8 can be networked with other readers on an enterprise 10/100
BaseT Ethernet LAN. Each reader is equipped with an embedded IP device server
that allows the unit to be assigned an IP address. This address can then be accessed
by your network server or host computer.
Figure 10–MP9320 V2.8 Ethernet LAN Communication Setup
Ethernet Link
B
B
a
a
y
y
N
N
e
e
t
t
w
w
o
o
r
r
k
k
s
s
RJ-45 Connector
D
i
git
a
l
I
/O
MP932
UHF R
eade
Fa
ult
Po
w
er
S
Acti
v
eAn
t
e
nna
1
2
3
4
RS-232
D
i
git
a
l
I
/O
RS
-
232
D
i
git
a
l
I
/O
RS-4
8
5
D
ig
i
t
a
l
I/
O
M
P9
320 2
.
8
EPC
U
H
F
Read
e
r
F
ault
P
ow
er
S
ens
e
T
r
ans
m
it
A
c
t
iv
e
A
nt
enna
1
2
3
4
T
h
e
P
o
w
e
r
t
o
C
h
o
o
s
e
T
M
Po
we
r
(1
5
V
d
c3
.0
a
mp
ma
x
)
E
th
e
r
n
e
t
L
AN
RS-
2
3
2