User's Manual
Table Of Contents
- Contents
- Figures
- Introduction
- Installation
- Operation
- Troubleshooting
- Specifications
- Reader Specifications
- Environmental Specifications
- Battery Specifications (Optional)
- Power Supply Specifications
- RS-232 Connector Specifications
- RS-485 Connector Specifications
- RS-485/Ethernet Jumper Setting
- Ethernet LAN Connector Specifications
- Digital I/O Connector Specifications
- Optional Communication Cable Specifications
- Suitable Antenna Specifications
- Regulatory Standards
- Reader Configuration
- Tag Programming
- Configuring the IP Address
Installation
17
Transmit Power Calibration
The MP9320 V2.8 can be operated with a variety of commercially available
antennas and coaxial cables. As a result, the output RF power of the reader must be
configured to optimize the read range for a given antenna configuration, while not
violating FCC or CE regulations.
Calibration of the reader transmit RF power must only be performed by SAMSys
authorized installation personnel or certified resellers.