User's Manual

MP9320 V2.8 User’s Guide
42
Operating Modes
SAMSys reader software is configurable to verify configuration parameters.
Typical reader parameters include the following:
• RF communication mode (polled or continuous)
• Serial communication mode (polled or continuous)
• Multiplexer Configuration (# antennas, inventory rounds, and antenna hopping)
• Serial multidrop addressing
• Protocol configuration
• Protocol selection
For detailed information on checking reader configuration, refer to the following
sections and the RF Command Suite User’s Guide.
Default Configuration
The factory default configuration is as follows:
• General Configuration
– RF Continuous
– Serial Continuous
• Serial Configuration
– 57600 Baud
– 8 Data Bits
–1 Stop Bit
–No Parity
• Multiplexer Configuration
–1 antenna
– Antenna hopping enabled
– 1 inventory round per antenna