User's Manual
Table Of Contents
- Contents
- Figures
- Introduction
- Installation
- Operation
- Troubleshooting
- Specifications
- Reader Specifications
- Environmental Specifications
- Battery Specifications (Optional)
- Power Supply Specifications
- RS-232 Connector Specifications
- RS-485 Connector Specifications
- RS-485/Ethernet Jumper Setting
- Ethernet LAN Connector Specifications
- Digital I/O Connector Specifications
- Optional Communication Cable Specifications
- Suitable Antenna Specifications
- Regulatory Standards
- Reader Configuration
- Tag Programming
- Configuring the IP Address
MP9320 V2.8 User’s Guide
44
Changing the RS-232 Configuration
To confiure the reader’s serial port parameters, perform the following:
1. Select the RS-232 UART parameters as shown in the following:
Figure 27 – RS-232 Serial Port Configuration
2. Make any changes using the pull-down menus and selectors on the right side
of the display and press Send Changes to Reader .
Changing Reader Operation Modes
The reader’s serial and RF modes can be configured for polled or continuous
operation. In addition, the RF On when Idle mode can be set. To change any of the
operating modes, perform the following:
1. Select the specific General Configuration Word (GCW) parameters as shown
in the following:
Figure 28 – Serial and RF Mode Configuration
2. Make any changes using the selectors on the right side of the display and
press
Send Changes to Reader .