User's Manual
Table Of Contents
- Contents
- Figures
- Introduction
- Installation
- Operation
- Troubleshooting
- Specifications
- Reader Specifications
- Environmental Specifications
- Battery Specifications (Optional)
- Power Supply Specifications
- RS-232 Connector Specifications
- RS-485 Connector Specifications
- RS-485/Ethernet Jumper Setting
- Ethernet LAN Connector Specifications
- Digital I/O Connector Specifications
- Optional Communication Cable Specifications
- Suitable Antenna Specifications
- Regulatory Standards
- Reader Configuration
- Tag Programming
- Configuring the IP Address
Reader Configuration
45
Configuring Specific Protocols
Individual Protocol Configuration registers can be modified for specific tag types
and read modes. For specific protocol configuration register information, refer to
the Comprehensive Heuristic Uniform Messaging Protocol (CHUMP) Reference
Guide. To configure individual protocol registers, perform the following:
1. Select the individual protocol configuration word parameters.
Figure 29 – Protocol Parameter Configuration
2. Enable or disable a specific protocol parameter by using the selectors on the
right side of the display and press Send Changes to Reader .