User's Manual
Table Of Contents
- Contents
- Figures
- Introduction
- Installation
- Operation
- Troubleshooting
- Specifications
- Reader Specifications
- Environmental Specifications
- Battery Specifications (Optional)
- Power Supply Specifications
- RS-232 Connector Specifications
- RS-485 Connector Specifications
- RS-485/Ethernet Jumper Setting
- Ethernet LAN Connector Specifications
- Digital I/O Connector Specifications
- Optional Communication Cable Specifications
- Suitable Antenna Specifications
- Regulatory Standards
- Reader Configuration
- Tag Programming
- Configuring the IP Address
51
Appendix B
Tag Programming
This appendix describes how to program tags of varying protocols using CHUMP
commands sent from a terminal or console.
Information provided in this appendix includes the following:
• Overview of the Tag Writing Command
• Programming the EPC1 Tag
• Programming the ISO 18000-6A Tag
• Programming the ISO 18000-6B Tag
• Programming the Impinj EPC0 Tag
• Programming the Matrics Class 0+ Tag