User's Manual
Table Of Contents
- Contents
- Figures
- Introduction
- Installation
- Operation
- Troubleshooting
- Specifications
- Reader Specifications
- Environmental Specifications
- Battery Specifications (Optional)
- Power Supply Specifications
- RS-232 Connector Specifications
- RS-485 Connector Specifications
- RS-485/Ethernet Jumper Setting
- Ethernet LAN Connector Specifications
- Digital I/O Connector Specifications
- Optional Communication Cable Specifications
- Suitable Antenna Specifications
- Regulatory Standards
- Reader Configuration
- Tag Programming
- Configuring the IP Address
Configuring the IP Address
69
25. From RF Command Suite, select Reader Connection J Disconnect. This will
disconnect any auto connected sessions.
26. Select Reader Connection J Connect via TCP/IP.
27. Select Reader Connection J AutoConnect to establish an Ethernet
connection.
28. Select the IP address of the reader from the popup list and press OK.
29. Select the Command interface tab and press the Version function key to verify
communication with the reader.