Installation Guide

10
Solid Concrete Wall Mounting
To temporarily mount the MP9320 to a solid concrete wall, SAMSys recommends
one-piece expansion type concrete anchors that accept a #10 screw and flat washer. To
install the MP9320 on a solid concrete wall, perform the following.
1. Refer to Figure 3, and mark the location of the mounting screws.
2. Drill the appropriate size hole for a expansion type anchor.
3. Install the anchors
4. Install the washers and insert the screws.
5. Tighten the screws to within .375” of the anchor.
6. Install the reader and finish tightening the screws.
Wood or Metal Wall Mounting
To temporarily mount the MP9320 to a wood or sheet metal wall, SAMSys
recommends either #10 x 1 inch wood screws or #10 x 3/4 inch sheet metal screws
and flat washers. To install the MP9320 on a wood or metal wall, perform the
following.
1. Refer to Figure 3, and mark the location of the mounting screws.
2. Drill the appropriate size hole for screws.
3. Install the washers and insert the screws.
4. Tighten the screws to within .375” of the surface.
5. Install the reader and finish tightening the screws.
Drywall Mounting
To temporarily mount the MP9320 to drywall, SAMSys recommends either #10
toggle bolts or #10 drywall anchors.
NOTE: There are many types of screw-in, hammer-in, and predrill drywall anchors.
Each one is designed for specific applications and pull-out ratings. Ensure that
the anchor you select has a pull-out rating of at least 12 lbs.
To install the MP9320 on drywall, perform the following.
1. Refer to Figure 3, and mark the location of the mounting screws.
2. Refer to the anchor manufacturers instructions for installing the anchors.
3. Install the washers and insert the screws.
4. Tighten the screws to within .375” of the surface.
5. Install the reader and finish tightening the screws.