Installation Guide

13
9. If the tag did not read correctly, use RF Command Suite to verify the reader
operating mode matches the application requirement. If necessary, reconfigure
the reader operating modes.
NOTE: Refer to the RF Command Suite User’s Guide and the Comprehensive Heuristic
Unified Messaging Protocol (CHUMP) Reference Guide for detailed information on
configuring the reader.
Ethernet LAN Communication Setup
The MP9320 can be networked with other readers on an enterprise 10/100 BaseT
Ethernet LAN. Each reader is equipped with an embedded IP device server that allows
the unit to be assigned an IP address. This address can then be accessed by your
network server or host computer.
Figure 5–MP9320 Ethernet LAN Communication Setup
Installing the RF Command Suite Application
The SAMSys RF Command Suite is a Microsoft Windows application that provides a
Graphical User Interface (GUI) for SAMSys RFID Reader Products.
The application
allows you to easily view tag data, configure the reader, and perform other tag data functions.
In addition, the RF Command Suite is the preferred method for sending CHUMP commands
to a reader. The RF Command Suite application is provided on the CD shipped with your
reader and can be installed on a personal computer. To install RF Command Suite, refer to
Chapter 1 - Introduction in the RF Command Suite User’s Guide.
Ethernet Link
RS-232
Power
(15 Vdc 2.5 am
p m
ax)
RS-485 & Digital
I/O
MP9320
UHF Long-Range Reader
Fault
Power
Sense
Transmit
Active Antenna
1
2
3
4
RS-232
Power
(15 Vdc 2.5 am
p m
ax)
RS-485 & Digital
I/O
MP9320
UHF Long-Range Reader
Fault
Power
Sense
Transmit
Active Antenna
1
2
3
4
RS-232
Power
(15 Vdc 2.5 am
p m
ax)
RS-485 & Digital
I/O
MP9320
UHF Long-Range Reader
Fault
Power
Sense
Transmit
Active Antenna
1
2
3
4
RS-232
Power
(15 Vdc 2.5 amp
max)
RS-485 & Digita
l I/O
MP9320 2.7 EPC
UHF Long-Ran
ge Reader
Fault
Power
Sense
Tra
nsmit
Active Antenna
1
2
3
4
B
a
y
Ne
t
wo
r
k
s
Ethernet LAN
Server or Hub
RJ-45 Connector