Installation Guide
Table Of Contents
- Contents
- Introduction
- Assumptions
- Getting Technical Assistance
- Antenna Installation
- Reader Mechanical Installation
- RS-485/Ethernet Communication Selection
- RS-485 Impedance Matching Selection
- Serial (RS-232) Communication Setup
- Ethernet LAN Communication Setup
- Installing the RF Command Suite Application
- Configuring the IP Address
- Digital (TTL) Input/Output Setup
- Setting Digital Input for Reader Duty Cycle Control
- Transmit Power Calibration
- Transmitter and Antenna Configuration
- Manual Field Power Calibration - FCC Readers
- Manual Field Power Calibration - ETSI Readers
16
Transmit Power Calibration
The MP9320 can be operated with a variety of commercially available antennas and
coaxial cables. As a result, the output RF power of the reader must be configured to
optimize the read range for a given antenna configuration, while not violating FCC or
ETSI regulations.
Calibration of the reader transmit RF power must only be performed by SAMSys
authorized installation personnel or certified resellers.