Installation Guide

4
Introduction
This document is intended to assist technical service personnel engaged in the
installation of the SAMSys MP9320 UHF Reader. The document includes procedures
for installing and configuring the reader to meet local standards and regulatory
requirements. Topics and procedures presented in this document include the
following:
• Antenna Installation
• Reader Mechanical Installation
• RS-485/Ethernet Communication Selection
• RS-485 Impedance Matching Selection
• Serial (RS-232) Communication Setup
• Ethernet LAN Communication Setup
• Installing the RF Command Suite Application
• Configuring the IP Address
• Digital (TTL) Input/Output Setup
• Setting Digital Input for Reader Duty Cycle Control
• Transmit Power Calibration
• Transmitter and Antenna Configuration
• Manual Field Power Calibration - FCC Readers
• Manual Field Power Calibration - ETSI Readers
Assumptions
This document is intended for technical personnel who are trained and experienced
with the setup and configuration of SAMSys radio frequency identification systems
including readers and antennas. Failure to correctly follow the procedures in this
manual may result in faulty reader operation that violated regulatory requirements.
Getting Technical Assistance
If you need assistance or have questions related to the installation or use of this
product, call or email SAMSys Technologies’ customer service department for
support.
E-mail [e-mail]
Telephone
1-877-367-4342 (toll free)
8:00am-6:00pm EST, Mon-Fri
Fax [phone]