Installation Guide
Table Of Contents
- Contents
- Introduction
- Assumptions
- Getting Technical Assistance
- Antenna Installation
- Reader Mechanical Installation
- RS-485/Ethernet Communication Selection
- RS-485 Impedance Matching Selection
- Serial (RS-232) Communication Setup
- Ethernet LAN Communication Setup
- Installing the RF Command Suite Application
- Configuring the IP Address
- Digital (TTL) Input/Output Setup
- Setting Digital Input for Reader Duty Cycle Control
- Transmit Power Calibration
- Transmitter and Antenna Configuration
- Manual Field Power Calibration - FCC Readers
- Manual Field Power Calibration - ETSI Readers
7
Antenna Installation Procedure
It is highly recommended that the antenna mounting be adjustable in order to obtain
the best performance from the system. However, the antennas must be installed on a
solid surface or frame to prevent damage or later misalignment. Perform the following
to install the antennas.
NOTE: Use the existing mounting holes on the antenna flange. Drilling new holes in
the flange is not recommended.
1. Determine the location of each antenna. Ensure the antenna(s) will not be
vulnerable to damage by moving inventory or equipment.
2. Use the antenna as a template and mark the mounting holes.
3. Drill and tap (if necessary) mounting holes for #10 or 1/4 inch mounting screws.
For drywall mounting, use drywall anchors or toggle screws.
4. Mount each antenna and install the mounting screws. Do not overtighten the
screws. Damage to the antenna case may result.
5. Route each antenna cable back to the reader location. For dual-opposing or
portal configurations, route the opposing cables so they can not be damaged by
equipment or personnel.
6. Secure each antenna cable with wire ties or other restraint.