User's Manual

SAMSys
MP9320 v2.8 UHF Reader
User’s Guide
First Edition (May 26, 2005)
© Copyright 2005 SAMSys Technologies, Inc. All Rights Reserved.
Disclaimer and Limitation of Liability
The content of this manual is for information use only and is subject to change without notice. SAMSys assumes no responsibility or liability for
any errors or inaccuracies that may appear in this publication. No part of this manual may be reproduced in any form or by any means,
electronic, mechanical, recording, or otherwise, without the prior written permission of SAMSys.
SAMSys products are not designed, intended, authorized or warranted to be suitable for life support applications or any other life critical
applications which could involve potential risk of death, personal injury, property damage, or environmental damage.
About SAMSys
SAMSys Technologies, Inc. is a world-leading provider of RFID reader hardware solutions in the LF, HF, and UHF segments of the RFID
marketplace. SAMSys is a public company listed on the Toroto Stock Exchange under the symbol SMY.
SAMSys Technologies, Inc.
44 East Beaver Creek Rd., Unit 11
Richmond Hill, Ontario L4B 1G8 Canada
Phone: [phone]
Toll Free: [phone]
Fax: [phone]
E-mail: [e-mail]
Web: www.samsys.com
Manual Part Number:
HI469320-28-UG-P1.2
Federal Communications Commission (FCC) Notice (Preliminary)
This device was tested and found to comply with the limits set forth in Part 15 of the FCC Rules. Operation is subject to the following conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received including interference that may
cause undesired operation. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment.
This device generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instruction manual, the
product may cause harmful interference to radio communications. Operation of this product in a residential area is likely to cause harmful
interference, in which case, the user is required to correct the interference at their own expense.
The authority to operate this product is conditioned by the requirements that no modifications be made to the equipment unless the changes or
modifications are expressly approved by SAMSys Technologies.
Trademarks
SAMSys is a trademark of SAMSys Technologies, Inc.
HyperTerminal
® is a registered trademark of Hilgraeve, Inc.
EPC is a trademark of EPCglobal, Inc.
Other company, product or service names appearing in this manual may be trademarks or service marks of their respective owners.