User's Manual
Table Of Contents
- Contents
- Figures
- Introduction
- Installation
- Operation
- Troubleshooting
- Specifications
- Reader Specifications
- Environmental Specifications
- Battery Specifications (Optional)
- Power Supply Specifications
- RS-232 Connector Specifications
- RS-485 Connector Specifications
- RS-485/Ethernet Jumper Setting
- Ethernet LAN Connector Specifications
- Digital I/O Connector Specifications
- Optional Communication Cable Specifications
- Suitable Antenna Specifications
- Reader Configuration
- Tag Programming
- Configuring the IP Address
Installation
15
Installing the RF Command Suite Application
The SAMSys RF Command Suite is a Microsoft Windows application that
provides a Graphical User Interface (GUI) for SAMSys RFID Reader Products.
The application allows you to easily view tag data, configure the reader, and perform other
tag data functions. In addition, the RF Command Suite is the preferred method for sending
CHUMP commands to a reader. The RF Command Suite application is provided on the
CD shipped with your reader and can be installed on a personal computer. To install RF
Command Suite, refer to Chapter 1 - Introduction in the RF Command Suite User’s
Guide.
Configuring the IP Address
The MP9320 V2.8 is equipped with a TCP/IP Ethernet port and embedded IP
device server. This reader is configured for automatic IP address allocation using
the Dynamic Host Configuration Protocol (DHCP) Mode and the reader
automatically extracts the IP address from the DHCP server. This is the default
mode for the reader as it is shipped from the factory.
In the event that you need to manually configure the IP address and Baud rate,
refer to Appendix C for detailed instructions.