User's Manual

MP9320 V2.8 User’s Guide
22
Selecting Tag Protocols
The MP9320 V2.8 is factory configured with only those protocols selected by the user.
Once protocols are activated, the
Command tab function keys can be used to select the
protocol. These function keys are programmed with specific command sequences required
by the reader to select a particular protocol. To select a protocol, perform the following:
1. Select the
Command interface window.
2. Select
Function Set 2 or 3 and locate the required protocol.
3. Press the function key to select the protocol.
4. To view the commands performed by this function, hold the mouse pointer over the
key or right click while holding the mouse pointer over the key and select
Edit Macro.
5. Do not change the command sequnce unless you are experienced using SAMSys
CHUMP commands to configure readers.
Enabling or Disabling Tag Protocols
If you are experienced with SAMSys reader configuration, you can enable, disable, or
modify protocols to match specific requirements. To verify which protocols are activated
for your reader, navigate to the Reader Config interface window and select:
Reader Configuration
D General Configuration D Operating Mode D
Protocol Select Mask
Activated protocols will be listed and whether they are enabled or disabled. To enable or
disable a different protocol, perform the following:
1. Select the Protocol Select Word (PSW) parameters as shown in the following:
Figure 14 – Protocol Selection
2. Enable or disable a protocol by using the selectors on the right side of the display
and press Send Changes to Reader . See the following note.
3. To modify the selected protocol, select the Protocol Configuration Word and
make any required changes.
NOTE: Only enable one protocol at a time. Enabling multiple protocols can result in reduced tag
reading performance.
For detailed information on reader configuration using RF Command Suite, refer to the
RF Command Suite Users Guide.