User's Manual
Table Of Contents
- Contents
- Figures
- Introduction
- Installation
- Operation
- Troubleshooting
- Specifications
- Reader Specifications
- Environmental Specifications
- Battery Specifications (Optional)
- Power Supply Specifications
- RS-232 Connector Specifications
- RS-485 Connector Specifications
- RS-485/Ethernet Jumper Setting
- Ethernet LAN Connector Specifications
- Digital I/O Connector Specifications
- Optional Communication Cable Specifications
- Suitable Antenna Specifications
- Reader Configuration
- Tag Programming
- Configuring the IP Address
39
Appendix A
Reader Configuration
This appendix describes how to change or update the MP9320 V2.8 Reader
configuration using the RF Command Suite. Refer to the RF Command Suite
User’s Guide for additional information.
Information provided in this appendix includes the following:
• Operating Modes
• Default Configuration
• Configuring the Reader with RF Command Suite
– Changing the RS-232 Configuration
– Changing Reader Operation Modes
– Configuring Specific Protocols
• Updating Reader Firmware with RF Command Suite
• Using CHUMP Commands to Configure the Reader