User's Manual

SARS MP9112 Owner’s Manual

3. Insert the AC adapter into a power outlet.

4. Insert the power supply cable into the power connector.

Refer to the SAMSys Multi-Protocol Reader Programmer’s Guide

for more information on configuring your reader.

RS-485 Communication Setup

The MP9112 communicates with the SAMSys Interrogator Control

and Concentrator Module (ICCM) using an RS-485 interface. To

set up a reader network with RS-485 communications, perform the

following steps:

1. Insert the 3-pin male plug on the RS-485 cable into the

3-pin connector on the end panel of the reader.

2. Insert the 25-pin female plug on the RS-485 cable into the

25-pin connector on the ICCM.

3. Insert the AC adapter into a power outlet.

4. Insert the power supply cable into the power connector on

the end panel of the reader.