User's Manual
Table Of Contents
- Contents
- Figures
- Introduction
- Installation and Setup
- Low-Power UHF Antenna Installation
- Reader Mechanical Installation
- Reader Electrical Installation
- Installing the System Connector Ribbon Cable
- Installing the RF Command Suite Application
- Ethernet LAN Communication Setup (MP9310-NE/EE Only)
- Setting Transmit Power - TD0
- Setting Antenna Gain - TG0 (MP9310-E/EE only)
- Digital Input/Output Setup
- Operation
- Troubleshooting
- Specifications
- Tag Programming
- Configuring the IP Address
Introduction
3
About the MP9310
The MP9310 is an integral UHF RFID module designed for use in transponder
printer/programmers and other tag manufacturing equipment. This compact, low-
power module is capable of operating at 902 to 926 MHz for the North American
version and 865 to 869 MHz for the European Version.
The MP9310 currently supports the following UHF protocols:
• ISO 18000-6A
• ISO 18000-6B
• EM Marin 4022, 4222, and 4223
• Intermec Intellitag
• Philips UCODE EPC 1.19
• EPC Class 1
• EPC Class 0 including Impinj 0+ and Matrics 0+
In addition to the multi-protocol architecture, the MP9310 includes the following
features:
• RS-232 Serial Port
• Digital input and output lines
• Ethernet LAN connection (optional)
Figure 2–MP9310 Reader Network (Optional Ethernet shown)
MP9310
Low-Power UHF
Reader Module
B
a
y
N
e
t
w
o
r
k
s
Ethernet LAN
Ethernet Hub
or
Network Server