User's Manual

MP9310 User’s Guide
8
Installing the System Connector Ribbon Cable
The System Connector ribbon cable is installed with the key way towards the end
of the enclosure. See Figure 6 for proper orientation of the ribbon cable connector.
Installing the RF Command Suite Application
The SAMSys RF Command Suite is a Microsoft Windows application that
provides a Graphical User Interface (GUI) for SAMSys RFID Reader Products.
The application allows you to easily view tag data, configure the reader, and perform other
tag data functions. In addition, the RF Command Suite is the preferred method for sending
CHUMP commands to a reader. The RF Command Suite application is provided on the
CD shipped with your reader and can be installed on a personal computer. To install RF
Command Suite, refer to Chapter 1 - Introduction in the RF Command Suite User’s Guide.
Ethernet LAN Communication Setup (MP9310-NE/EE Only)
The MP9310-NE/EE is equipped with an optional TCP/IP Ethernet port and
embedded IP device server. This reader is configured for automatic IP address
allocation using the Dynamic Host Configuration Protocol (DHCP) Mode and the
reader automatically extracts the IP address from the DHCP server. This is the
default mode for the reader as it is shipped from the factory.
In the event that you need to manually configure the IP address and Baud rate,
refer to Appendix B for detailed instructions.
Caution
In order to comply with FCC radiated emissions requirements, MP9310 models with the optional
Ethernet connector must use Category 5 shielded cables.