User's Manual

SAMSys
MP9310 Low-Power UHF Reader Module
User’s Guide
Second Edition (February 2005)
© Copyright 2005 SAMSys Technologies, Inc. All Rights Reserved.
Disclaimer and Limitation of Liability
The content of this manual is for information use only and is subject to change without notice. SAMSys assumes no responsibility or liability for any errors
or inaccuracies that may appear in this publication. No part of this manual may be reproduced in any form or by any means, electronic, mechanical,
recording, or otherwise, without the prior written permission of SAMSys.
SAMSys products are not designed, intended, authorized or warranted to be suitable for life support applications or any other life critical applications
which could involve potential risk of death, personal injury, property damage, or environmental damage.
About SAMSys
SAMSys Technologies, Inc. is a world-leading provider of RFID reader hardware solutions in the LF, HF, and UHF segments of the RFID marketplace.
SAMSys is a public company listed on the Toroto Stock Exchange under the symbol SMY.
SAMSys Technologies, Inc.
44 East Beaver Creek Rd., Unit 11
Richmond Hill, Ontario L4B 1G8 Canada
Phone: [phone]
Toll Free: [phone]
Fax: [phone]
E-mail: [e-mail]
Web: www.samsys.com
Part Number:
HI469310-01-UG-V2.3
Federal Communications Commission (FCC) Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.The authority to operate this product is conditioned by the requirements that no
modifications be made to the equipment unless the changes or modifications are expressly approved by SAMSys Technologies.
In order to comply with FCC radiated emissions requirements, the MP9310 with the optional Ethernet port must use a Category 5 shielded cable.
FCC Radiation Exposure Statement
The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
Trademarks
SAMSys is a trademark of SAMSys Technologies, Inc.
HyperTerminal
® is a registered trademark of Hilgraeve, Inc.
EPC is a trademark of EPCglobal, Inc.
Other company, product or service names appearing in this manual may be trademarks or service marks of their respective owners.