User's Manual
Table Of Contents
- Contents
- Figures
- Introduction
- Installation and Setup
- Low-Power UHF Antenna Installation
- Reader Mechanical Installation
- Reader Electrical Installation
- Installing the System Connector Ribbon Cable
- Installing the RF Command Suite Application
- Ethernet LAN Communication Setup (MP9310-NE/EE Only)
- Setting Transmit Power - TD0
- Setting Antenna Gain - TG0 (MP9310-E/EE only)
- Digital Input/Output Setup
- Operation
- Troubleshooting
- Specifications
- Tag Programming
- Configuring the IP Address
Operation
13
Enabling Protocols
SAMSys readers can be configured with different tag protocols. If your reader was
loaded with specific protocols at the time of purchase, these protocols can be
enabled or disabled as required. To verify which protocols are enabled for your
reader, select:
Reader Configuration
D
General Configuration
D
Operating Mode
D
Protocol Select Mask
To configure the reader for a specific protocol, perform the following:
1. Select the Protocol Select Word (PSW) parameters as shown in the
following:
Figure 8 – Protocol Selection
2. Enable or disable a protocol by using the selectors on the right side of the
display and press Send Changes to Reader .
Configuring Specific Protocols
Individual Protocol Configuration registers can be modified for specific tag types
and read modes. For specific protocol configuration register information, refer to
the Comprehensive Heuristic Uniform Messaging Protocol (CHUMP) Reference
Guide. To configure individual protocol registers, perform the following:
1. Select the individual protocol configuration word parameters.
Figure 9 – Protocol Parameter Configuration
2. Enable or disable a specific protocol parameter by using the selectors on the
right side of the display and press Send Changes to Reader .