User's Manual

MP9310 User’s Guide
16
Writing Blank Tags
RF Command Suite can be used to write unprogrammed or blank tags. To write
blank tags, perform the following:
1. Select the Command interface and verify the reader is connected and the
correct protocol is selected.
2. Place the reader in Polled Read mode.
3. Verify a single tag is in the RF field of the reader.
4. Select the Tag Summary interface.
5. Select the protocol from the pull-down above the Write Blank Tag button.
Figure 12–Select Tag Protocol
6. Press the Write Blank Tag button to begin the operation and
display the tag data box.
Figure 13–Write Blank Tag
7. Fill in the appropriate data (in Hex) and press the Write button to
write the data to the tag.
NOTE: For detailed information on the various tag protocols and how each protocol is
programmed, refer to Appendix A –Tag Programming.