User's Manual
Table Of Contents
- Contents
- Figures
- Introduction
- Installation and Setup
- Low-Power UHF Antenna Installation
- Reader Mechanical Installation
- Reader Electrical Installation
- Installing the System Connector Ribbon Cable
- Installing the RF Command Suite Application
- Ethernet LAN Communication Setup (MP9310-NE/EE Only)
- Setting Transmit Power - TD0
- Setting Antenna Gain - TG0 (MP9310-E/EE only)
- Digital Input/Output Setup
- Operation
- Troubleshooting
- Specifications
- Tag Programming
- Configuring the IP Address
MP9310 User’s Guide
26
Environmental Specifications
Power and Input/Output Connectors
System Connector (SCON1) Specifications
Specification Value
Operating
Temperature
-4° F to 131° F (-20° C to 55° C)
Storage Temperature -40° F to 176° F (-40° C to 80° C)
Relative Humidity 5% to 80% non-condensing
Pin No. Name Signal/Value
18,20,22,24,26 PWR System Supply Voltage, 5.0 Vdc +/-10%,
2.3A Max
3,10,12,14,16,17,
19,21,23, 25
GND Common
Pin 1 V33 3.3 Vdc
Pin 2 PROG Program Enable
Pin 4 RESET Active Low Reset
Pin 5 DIN1 Digital Input 1,
3 to 25 Vdc, 1 to 5A, Optically Isolated
Pin 6 DIGND1 Reference for DIN1
Pin 7 DIN2 Digital Input 2,
3 to 25 Vdc, 1 to 5A, Optically Isolated
Pin 8 DIGND2 Reference for DIN2
Pin 9 DOUT1 Digital output 1
50 Vdc, 40 mA, Open Collector to Ground
Pin 11 DOUT2 Digital output 2
50 Vdc, 40 mA, Open Collector to Ground
Pin 13 TXD Transmit
Pin 15 RXD Receive
Ethernet (optional)
System Connector [SCON1]
125
26 2
System Connector