User's Manual
Table Of Contents
- Contents
- Figures
- Introduction
- Installation and Setup
- Low-Power UHF Antenna Installation
- Reader Mechanical Installation
- Reader Electrical Installation
- Installing the System Connector Ribbon Cable
- Installing the RF Command Suite Application
- Ethernet LAN Communication Setup (MP9310-NE/EE Only)
- Setting Transmit Power - TD0
- Setting Antenna Gain - TG0 (MP9310-E/EE only)
- Digital Input/Output Setup
- Operation
- Troubleshooting
- Specifications
- Tag Programming
- Configuring the IP Address
Specifications
27
Ethernet LAN Connector (Optional)
Figure 16–Ethernet LAN Connector
Pin Number Signal
Pin 1 TXD+ (Transmit Data +)
Pin 2 TXD- (Transmit Data -)
Pin 3 RXD+ (Receive Data +)
Pin 4 EPWR+ (Power from switch +)
Pin 5 EPWR+ (Power from switch +)
Pin 6 RXD- (Receive Data -)
Pin 7 EPWR- (Power from switch -)
Pin 8 EPWR- (Power from switch -)
Network Link LED Yellow LED indicates network link is
operational. On continuously indicates Ethernet
Network Activity LED Green LED indicates network traffic detected.
Pin 1
Pin 8
Network Link
LED (yellow)
Network Activity
LED (green)